Shark DG-2324 Instrucciones de operaciones descargar pdf (Pagina 6)

96-716, 97-718, 97-720 • REV. 4/07

OPERATOR’S MANUAL

PRESSURE WASHER

6

STEP 1: Attach the handle to the

frame of the pressure washer. Note:

It may be necessary to move the

handle supports from side to side

in order to align the handle so it will

slide over the frame supports.

STEP 2: Insert the carriage bolt

through the holes from the outside

of the unit and attach a nut from

the inside of the machine. Tighten

nuts.

STEP 3: Attach the spray gun/hose

storage handle and bracket to

handle. Tighten nuts.

STEP 4: Attach the high pressure

hose to the spray gun using teﬂon

tape on hose threads.

STEP 7: Release the coupler collar

and push the nozzle until the collar

clicks. Pull the nozzle to make sure

it is seated properly.

STEP 8: Connect the high pres-

sure hose to the discharge nipple.

Push coupler collar forward until

secure.

STEP 5: Attach nozzle extension

to spray gun/wand. Tighten both

by hand.

STEP 6: Pull spring-loaded collar

of the wand coupler back to insert

your choice of pressure nozzle.

STEP 9: Connect garden hose to

the cold water source.

ASSEMBLY INSTRUCTIONS

STEP 10: Check inlets ﬁlters, remove debris,

then connect the garden hose to pump water

inlet. CAUTION: Do not run the pump without

water or pump damage will result.

Alignment

Holes

Handle

Frame

Assy.

Carriage

Bolt

Nut

Studs

Nut

Hose/Gun

Storage

Bracket

Safety

Latch

Spray

Gun

High

Pressure Hose

Nozzle Extension

Spray

Gun/Wand

Wand

Coupler

Pressure

Nozzle

Pressure

Nozzle

Wand

Coupler

Coupler

Collar

Discharge

Nipple

High

Pressure

Hose

Cold

Water

Source

Garden

Hose

Pump

Water Inlet

Garden

Hose

Coupler

Collar

Bolts

1 2 3 4 5 6 7 8 9 10 11 ... 31 32

Comentarios a estos manuales

Sin comentarios